Align M690L Multicopter Landing Gear Offset
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This was made to change the position of the landing gear of Align M690L Multocopter, so you can use larger batteries.…
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 13
- Wydruki
- 0
- Wyświetlenia
- 77
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This was made to change the position of the landing gear of Align M690L Multocopter, so you can use larger batteries.
Ive printed ABS, 0.3mm, 50% infill with support. Its very strong in this configuration. The outer 2 holes are thinner, so you can attach the bolts without the need to drill the carbon fiber chassis plate.
Added a small space under the part to route the camera wire.
Print Settings
Printer Brand:
TEVO
Printer:
Tarantula
Rafts:
No
Supports:
Yes
Resolution:
0.3mm
Infill:
50%
Notes:
Ive printed ABS. It didnt get pretty, but will do the job. Maybe PLA is strong enough.
Category: R/C Vehicles