Hitbox with Cherry-MX-Switches v1
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a Hitbox like Fight-Controller with Cherry-MX-Swtiches, using a Pi Pico as the control.
- Ocena
- 0 / 5
- Polubienia
- 8
- Pobrania
- 61
- Wydruki
- 0
- Wyświetlenia
- 734
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Video Games
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I wanted to 3D print my own Hitbox controller without spending too much on buttons. Instead, I disassembled an old Cherry MX keyboard to salvage its switches and keycaps. To begin, I had to ensure the switches fit correctly, so I printed the test.stl file to verify the switch mounting dimensions (14x14x1.5).
The Pi Pico is secured in place with mounting pins. I left a hole at the back for the cable, although there's no strain relief on it. Perhaps version 2 will include that feature.
To enclose everything, I used 10x2mm magnets. The pocket holes are snug, so no glue was necessary.
Here's what you'll need for this project:
- 14 Cherry MX switches
- 14 keycaps
- 1 Pi Pico + USB cable
- Up to 16 magnets, maximum size 10x2mm (smaller ones might work as well)
- Wires and a small amount of soldering
- Firmware for the Pi Pico: Link
I'm looking to build upon this design, so if you have any suggestions or feedback, please share them with me.