JerryRigEverything Knife box with lid and MAGNETS (Gridfinity & normal)

This is a remix of Palte's “JerryRigEverything Knife box with lid (Gridfinity & portable)” storage block for the Jerryrig Everything box cutter knife (https://www.printables.com/model/444318-jerryrigeverything-knife-box-with-lid-gridfinity-p). 

I added magnet holes on the lid to hold it in place against the Knife Box and magnets in the knife block to hold down the knife and spare blades. Please insert the blades long side down and the knife with the clip facing down. 

Magnets needed:

8 6x2mm circular disk magnets for lid and knife block

TIP:

If you reverse the polarity of the magnets on opposite edges it will force the lid to go on in the correct orientation with the hole in the lid for the spare blades container in the right place every time. 

2 10x2mm circular disk magnets for holding the knife to the knife block

2 10x2mm circular disk magnets for holding the spare blades to the knife block

Printing Suggestions:
Add lots of walls (or perimeters,) as the surrounds for the magnet holes should be almost all wall so as to not break when peening the magnets in with a hammer. I needed to super glue the magnet that sticks to the knife as the surround is very thin to allow some finger access. 

I also used 30% infill for some extra durability but that one is up to you.