1999 to 2004 Jeep Grand Cherokee (WJ) cubby phone or tablet mount base
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
The WJ Jeep ... AKA The 1999 to 2004 Jeep Grand Cherokee has an odd cubby in the dash. This fits there to mount a phone
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 43
- Wydruki
- 0
- Wyświetlenia
- 1271
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Automotive
- Licencja
- Creative Commons — Attribution — Noncommercial
All files updated 2023-09-23.
If you have a 1999 to 2004 Jeep Grand Cherokee(AKA WJ), you may have wondered what you might put in the little dash cubby … or you might just have stuffed random things there. This printable will fit in there, still allow you to store stuff, and serve as a mounting base for a tablet or cell phone for the car. Conveniently right near the two power points (one switched one always on) … and able to mount something below the eyeline of the driver while still allowing access to the essential switchgear.
You should probably print this in PETG and you should probably print the top “upside down”. Remove the rubber mat from the cubby if you still have it.
The Cell Phone holding part is also parameterized. Note that it doesn't use resizing grippies — you have a printer, so set the size for your own phone/tablet. I've also set it to 20 degrees tilt back — you'll need to futz with things a bit to change that… notably the part that sticks out in the back.
Included, also, is a stick. It has little cubes on it's ends. You saw those off. They're present in the print to give bed-adhesion to the round parts. You may also have to slightly buff the holes with a file for it to fit. YMMV.
If you used, instead, a rod or dowel (size the holes to fit) you might get the phone above the dash — in which case it could double as a dash cam. I've even seen trip/mapping/engine monitoring apps that use the dash cam … so that could be cool. However, 250mm (plus two 10mm cubes on the end) is the max I can print diagonally corner-to-corner on my printer. Again, you can adjust the parameters to your own situation.
In my WJ, it friction fits with the little take sticking into the same opening the rubber mat does. I've found, with the test “file” in the picture that it stays put quite well. Might apply some double sided tape to the finished product, but it may not need it.
The OpenSCAD file is fairly well parameterized. If you make small changes the model should be OK. If you make large changes … well … YMMV. But increase h1 or h2 to move the top up. Urm… you might have to change the angle of the top rod-holder …
Well… it's OpenSCAD. UTSL.