Soft Drinks Can Dispenser (UK cans)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Drinks can dispenser sized for UK (330ml) drinks cans.
- Ocena
- 5 / 5
- Polubienia
- 61
- Pobrania
- 396
- Wydruki
- 4
- Wyświetlenia
- 2123
- Oceny
- 3
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Kitchen
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Drinks can dispenser sized for UK soft drink cans (330ml, ~66mm diameter and 125mm height).
This is my own design, created after difficulties finding or adapting an existing design for UK can sizes. Optimized for a 0.6mm nozzle (but probably printable just fine with 0.4mm).
Only requires some small supports for the pegs. Recommend the “Snug” setting in PrusaSlicer. Pegs are for alignment and you will need to super glue it together.
I… think… that Australia and New Zealand have the same sized cans, but I don't know that for sure.
I didn't print this on my Prusa Mini, but I think you could print one piece at a time on the Mini.
FOR BEST RESULTS: Print the vertical pegs (not the horizontal ones) as outer perimeter first (to ensure dimensional accuracy so they fit into the corresponding holes) and 100% infill (for strength). Settings for the rest of the model don't matter. I've set this up in the 3MF file using modifiers. This isn't specific to this model, but no one ever seems to mention it!