1 / 1
Honeycomb monitor stand — zdjęcie 1

Honeycomb monitor stand

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Simple honeycomb end pieces I made for a monitor stand. Dimensioned for 1.5 cm thick plywood or similar.

Ocena
4,962 / 5
Polubienia
2528
Pobrania
4276
Wydruki
26
Wyświetlenia
34 260
Oceny
26

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Office
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

Simple honeycomb end pieces I made for a monitor stand. Dimensioned for 1.5 cm thick plywood or similar. About 17.5 cm deep.

I uploaded a version without and two versions with brackets. I also made a middle brace that can be put in the back to avoid sagging shelves if you make it very wide.

Print instructions

I upped the bed temp to try to avoid warping in the corners. You can also try to warm the bed longer before printing to ensure it is properly warm all over, and print in an enclosure.
I printed in PETG to avoid sagging on a hot summer day, and used three perimeters for added strength.

Tagi