3-in IPL Ebay Sled for Eggtimer Quantum
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Preconfigured for Eggtimer Quantum and 2x 2S LiPo
- Ocena
- 0 / 5
- Polubienia
- 5
- Pobrania
- 58
- Wydruki
- 2
- Wyświetlenia
- 373
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Building off of a great design, I customized the ebay sled to work with my specific requirements. This is for the 3-in scaled-down version that I remixed. Here are the modifications I implemented:
- Opened up the hole in the threads to accommodate a 3/16-inch nut to pair with the 3/16-inch eye bolt.
- Added two, small holes at the base of the sled deck to route e-matches from one side to the other
- Added four, slots for Velcro straps to secure two, 2S Li-Po batteries
- Added standoffs spaced specifically for the Eggtimer Quantum Flight Computer
- Added a hole for a 3/16-in all-thread rod to add additional nose weight, if needed
Note: The standoffs got a little droopy without supports. If this bothers you, then add a little bit right to the bottom. Otherwise, no supports are necessary.
I printed this in PLA+ with 15% infill, at .2 resolution. I used 3 perimeters (usually 4) and I added a brim of 15mm just to keep it from breaking off.
This model was remixed from Inverted Pursuits Labs (IPL). Check out their Printables page or their YouTube channel.
You can also check out my rocket launches on my channel found HERE.
Important Note: Always double-check your dimensions and do test prints