Simple gaming/office chair wheel stoppers
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Made these for my gaming chair, to hold it steady while I'm wrestling with the steering wheel and jumping on the pedals.
- Ocena
- 5 / 5
- Polubienia
- 17
- Pobrania
- 214
- Wydruki
- 2
- Wyświetlenia
- 1530
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other House Equipment
- Licencja
- Creative Commons — Public Domain
These fit wheels approx. 54 mm wide and diameter of 55 mm. For different sizes you may want to try scaling these up or down a bit. Measure the size before you print, to avoid disappointments. :)
The idea is that the wheel rests on the floor, through the hole on the bottom, not on the stopper itself. Therefore sufficiently correct size is important.
I printed them with PLA, 0.8 mm nozzle and 50 % honeycomb 3D infill. Other nozzle sizes will most probably work just as well, but do use sufficient infill to make it strong enough.
If your chair is on a carpet, then you only need to print a couple of these. However, if it's on a hard floor (or your carpet is slippery), you might want to put these on a piece of anti-slip mat (see images), or glue them on the bottom of these.
Two or three pieces should be enough, no need to put these under every wheel. Depending on how much you move during playing, of course. Two is enough to keep me steady racing a car game.