Paracord Winder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A remix of @IvoSlanina's great 'Rope Winder' model, adapted to accommodate 550 paracord and use 40% less filament
- Ocena
- 4,872 / 5
- Polubienia
- 675
- Pobrania
- 2412
- Wydruki
- 45
- Wyświetlenia
- 7965
- Oceny
- 39
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor Sports
- Licencja
- Creative Commons — Attribution — Noncommercial
This is a remix of @IvoSlanina's great Rope Winder model.
I took some material out of the centre so it prints faster, using 40% less filament. It's still very strong.
I also increased the hole diameters from 4mm to 5.5mm because I couldn't get 550 paracord through the 4mm holes.
The first image shows 31m/101ft of paracord wrapped around it, the last image is a comparison of hole sizes from the original model and this remix.
I printed this using PLA+ on an MK3S+ using the following settings:
- 0.6mm nozzle
- '0.35 (SPEED)' layer height setting in Prusa slicer
- 2 perimeters
- 15% Grid infill