Flashlight Holder for Coast HP1 LED Flashlight
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I keep this little Coast HP1 LED Flashlight in the door panel of my truck, but I hated it rattling around. I used some…
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 33
- Wydruki
- 0
- Wyświetlenia
- 272
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Office
- Licencja
- Creative Commons — Attribution
I keep this little Coast HP1 LED Flashlight in the door panel of my truck, but I hated it rattling around. I used some Joe's Sticky Stuff (this is great stuff BTW) to attach it to the plastic inside the truck.
This is where I wanted it, here was a test fit of just the flashlight:
Here it is installed:
Print Settings
Printer Brand:
Prusa
Printer:
Rafts:
No
Supports:
No
Resolution:
0.2mm
Infill:
20%
Notes:
Make sure to orient the flat surface on the bed (should be the default orientation of the part), printing it any other way will cause you some headaches.
I used PLA, I fully expect this thing to melt in my truck (in hot Florida sun). Will see what happens, if it does I'll re-print in PETG or something like that.
Category: Organization