Wallet for Flexible Filament with space for Tile
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I really liked @makerseth's design but wanted to add some space for my Tile. I created the model from scratch however…
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 19
- Wydruki
- 0
- Wyświetlenia
- 211
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Fashion Accessories
- Licencja
- Creative Commons — Attribution
I really liked @makerseth's design but wanted to add some space for my Tile. I created the model from scratch however in Fusion 360. In my first print, I mistakenly made the diameter of the circle to show the tile 27mm instead of 16. I've fixed that in this STL but have not re-printed.
The wall in front of the tile is only 2 perimeters thick, could probably be a bit thicker but it seems to work so far. Going to trial this out for a couple of weeks and see if there are any changes I'd like to make.
In the pictures I have a single bill, 5 bills and 11 bills. They all stay in just fine. I have 6 cards in there, my normal carry. Any less than that and they will fall out. I plan on making some retention areas on the updated design in a week or so to protect against this.
Print Settings
Printer:
Prusa i3 Mk2
Rafts:
No
Supports:
No
Resolution:
0.2
Infill:
.30
How I Designed This
Used Autodesk Fusion 360
Made a sketch, added some fillets, then extruded each section to the appropriate heights. I added some 3d fillets around the cash area but no where else. Punched a 27mm (whoops now 16mm) hole in the center of the Tile holder.
This is designed for Ninjaflex 1.75mm filament with a .40mm tip and a .48mm extrusion width. Sliced with Simplify3D.Sketch
Model
Category: Accessories