1 / 6
MFJ-419 CW Helper Stand
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Use PLA if indoors, in an area not exposed to sun. Friends don't let friends use PLA Outdoors, exposed to heat, or in…
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 7
- Wydruki
- 0
- Wyświetlenia
- 43
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Ideas
- Licencja
- Creative Commons — Attribution — Noncommercial
- Use PLA if indoors, in an area not exposed to sun. Friends don't let friends use PLA Outdoors, exposed to heat, or in direct sunlight.
- This stand was a quick attempt to have a two angle positioning for the MFJ419 CW Trainer. Without a stand, placing the trainer flat on the back would resulted in muffled audio without headphones. But you could see the LCD. With the trainer standing straight up, you get good audio, but cannot see the LCD as well. So, there's this stand which partially puts the stand at an angle, exposes the speaker for better audio (and may even push it to more "Front firing" audio, and looks not too horrible.
I also printed up one for my nano VNA and it at least gives the nano VNA somewhere to sit and look cool.
www.youtube.com/c/hamradiodude
Print Settings
Printer Brand:
Longer
Printer:
Longer LK5 Pro
Rafts:
No
Supports:
Yes
Resolution:
.2
Infill:
40
Filament: Zyltech PLA Hot Rod Red
Notes:
- Printing the stand at 90 degree rotation from where it currently is will probably make it a stronger print. a tree support probably isn't needed (any support really), but I added it for the front of the stand/bed area.
Category: Other