Wizard Staff with Gem Topper for Kids
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Wanted something that my daughter could use that didn't cost over 150 dollars. :)
- Ocena
- 5 / 5
- Polubienia
- 34
- Pobrania
- 175
- Wydruki
- 3
- Wyświetlenia
- 1612
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Cosplay & Costumes in general
- Licencja
- Creative Commons — Attribution — Noncommercial
I personally ran into two issues with the original model (which is an amazing model!!!) First the cut parts of the staff didn't fit properly on my X1C, so i shrunk them down to 85%. Second, I didn't want to purchase a 150 dollar flashlight, so I removed the moon and crystal topper and replaced it with a simpler crystal gemstone. I wanted something simple that my daughter could use.
I printed this on an X1C and P1P printer with standard .2mm settings and 15% infill.
No supports required, but I did add a brim to the Gem to keep it in place while it printed.
Picked up a small flashlight at my local ACE hardware store for about $5 and it fit in pretty well.
I have attached the 3mf for those who would like it.
Filament used:
Staff: AMOLEN Dark Wood Walnut PLA Filament 1.75mm,Walnut 3D Printer Filament with 30% Real Wood Fiber,Wood Filament,1KG
Gem: ZIRO PLA Translucent Filament 1.75mm,3D Printer Filament PLA PRO Translucent Series 1.75 1KG(2.2lbs), Dimensional Accuracy +/- 0.03mm,Translucent Green