Replacement for Toyota 904664-00306 Clip
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Replaces Toyota 904664-00306 clip for 6-mm ID vacuum hoses that connect to the power steering air control valve
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 30
- Wydruki
- 0
- Wyświetlenia
- 185
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Automotive
- Licencja
- Creative Commons — Attribution
This is a part that probably no one else will need, but you can't get original Toyota ones anymore, so maybe this will help someone. This is made to replace the Toyota 904664-00306 clip that holds the 6-mmm ID vacuum lines that connect from the throttle body and intake over the top of the rocker cover to the air control valve on the power steering pump.
The low version holds the lines lower down, closer to the rocker cover, than the factory unit according to the images I have seen online. The not-low version should be closer to stock, but I don't have a factory unit to compare to.
Uses an M3 3-mm X 5-mm heat-set nut and an M3X5-mm set screw to keep the clip attached to the strut.
Printed versions shown is 70% fill ASA at 0.35-mm layer height. Material is Sunlu ASA in black. The material you select must be tough (ASA or ABS). A brim can be helpful and support is also helpful for the hole for the heat set nut.
I had one in PETG that just disappeared. The first ABS one warped a bit but was still useful.
Image shows close-up of installed part, and a wider shot of the location in the engine bay (1995 Pickup, 22RE)