Laptop bracket for hanging on desktop PC (home office setup)

This is a laptop holder I designed for my home office work. The laptop slides into the pieces and is held vertically with the lid in its closed position. The design is slightly parametric and can be adjusted to different laptop sizes by changing the wood pieces. You can find the lengths I used in the bill of material below. A laptop thickness will require a redesign of the top hook. Currently the design fits a laptop 332 x 22,5 x 229mm.

It is designed to hang of the case of my desktop PC case. But it might fit other case or setups to, see the dimensions in the drawings. It is based on 19,7 x 10mm wood which slots into the printed parts. The top hooks engages the case and support the weight. On the bottom is a stand off which leans against the case. 

Parts needed:

• 2x printed upper bracket
• 2x printed lower bracket
• 2x wood 19,3 x 10 x 238mm
• 1x wood 19,3 x 10 x 278mm
• 12x wood screws 3,5x12mm

Assembly:

• Depending on the wood and screw you use, you might want to pre-drill the holes in the wood.
• Screw bottom brackets to the 278mm wood piece through the inside.
• Insert vertical wood pieces into the bottom brackets and insert screws from the side.
• Put top brackets on wood pieces and fix with screws.

Print instructions:

• Measure the wood you will use. Maybe scale the models in the slicer to fit.
• Make sure you adjust for shrinkage and have a tuned machine. The wood slots into the printed pieces so good dimensions are advised.
• No supports needed
• Recommended layer height 0,2 mm

I would be happy to see some of your makes posted :)

Source files in the Alibre Atom format is available but the website does not allow the upload. If you need it send me a message.