1 / 6
Paracord Keychain with a Secret - Hidden Emergency Survival Firestarter or Fishing Kit Inside Monkey's Fist — zdjęcie 1
1 / 6

Paracord Keychain with a Secret - Hidden Emergency Survival Firestarter or Fishing Kit Inside Monkey's Fist

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

3D printed ball inside holds survival gear. Also included are a jig to tie the knot and a mold to make the firestarter.

Ocena
5 / 5
Polubienia
150
Pobrania
224
Wydruki
1
Wyświetlenia
3680
Oceny
1

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution

This idea was inspired by the survival paracord bracelets that are meant to ensure the wearer always has a length of cord.  I always liked the Monkey's Fist knot, and thought why not put something useful inside rather than a wooden ball?

With this, you get your length of cord and a firestarter or basic fishing kit (hook, line, and bobber) too.

Total cost one each of these should be well under $1 and could be a good project for older kids, youth groups, or scouts.

 

Firestarter Cubes

You can mold the firestarter cubes using the mold model. 

Tips for molding: 

sand mating surface of die haves with sandpaper on a flat surface.  This will reduce gap to minimize wax leaking.

heat wax with a double boiler type system (set the wax jar in hot water)

Don't overfill the mold with sawdust or other media,  this will prevent wax from filling cavity

Warm mold and media before pouring.  I used my filament dehydrator at 65C.  This might not be necessary, but it should help the wax fill the cavity before solidifying.

cool mold in freezer to make separation easy

 

If you are going to make a lot of these, you make want to find a faster way to make firestarter cubes ( maybe make a big block and cut off pieces)

 

 

Printing tips:

I printed everything in PLA with 0.6 Nozzle

No models require support

Print fishing kit with a brim, model has a small flat on one side.  orient this against the bed.  Use minimal infill (so it floats well, It's your bobber)

You may want to increase the walls on the knot jig for toughness.

 

Tagi