1 / 5
Automatic vegetable and fruit washer- no supports and no assembly required. Small and large sizes
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Set under the tap and watch the vegetables spinning on it. Prints in one piece with no supports.
- Ocena
- 4,861 / 5
- Polubienia
- 3581
- Pobrania
- 31 707
- Wydruki
- 177
- Wyświetlenia
- 79 947
- Oceny
- 165
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Kitchen
- Licencja
- Creative Commons — Attribution — Share Alike
SzczegółyPliki (6)Wydruki i komentarze (Wydruki: 177) (Komentarze: 204)Remiksy (1)Kolekcje (4608)Powiązane
Modeled from scratch, inspired by lwx007's design: Thingiverse #5685812
I saw some comments about difficulties with the original model requiring assembly or gluing, and decided to make a model that can be printed in a single piece and without any support, since PETG doesn't handle supports well.
- Two sizes available:
- Small → for small berries, small leaves, and small portions of grapes and cherry tomatoes
- Large → for larger salad leaves and larger berries, or large portions of grapes and cherry tomatoes
- Works better in PETG (PLA may leak)
- The walls are made thin to save material and print fast, but it's perfectly strong in the default sizes. Be careful when resizing the design
- If your sink has low flow, you may need to block some of the drain holes
Made on Onshape.
Step files included.