1 / 3
Super PINDA (SPINDA, S.P.I.N.D.A) Height Adjustment Tool, mounts into 3030 extrusion — zdjęcie 1
1 / 3

Super PINDA (SPINDA, S.P.I.N.D.A) Height Adjustment Tool, mounts into 3030 extrusion

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Tool to adjust the height of the Super PINDA (SPINDA) sensor on Mk3S(+)/Mk3.5 and Mini(+)

Ocena
4,879 / 5
Polubienia
992
Pobrania
4931
Wydruki
202
Wyświetlenia
22 928
Oceny
198

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Accessories
Licencja
Creative Commons — Attribution — Share Alike

Useful for finding the right distance of the Super PINDA from the print bed. The optimal distance for the Super PINDA is about 1.5mm. That should get your optimal Live Z/first layer calibration to somewhere around -1.00, so you'll have plenty of wiggle room for fine-tuning up and down. Most credit cards/zip ties are too small to find that ideal height.

Remix of With_Maltodextrin's model, which in turn was inspired by my original version. This version is thicker than With_Maltodextrin's version, to make it easier to insert and remove from the 3030 extrusion.

I have mine mounted on the Z axis of the Mini and the Y axis of the Mk3S.

Prints without supports, 0.2 or 0.3 mm, standing up.

NOTE: From the comments you can see that for some it comes out at exactly 1.5mm, for others closer to 1.4 or 1.6, depending on your printer's calibration, settings, etc. In the end, it doesn't matter if the distance is exactly 1.5 mm. Either way, it will bring you into the right ballpark, and it's a lot better than zip ties or credit cards with ill-defined heights.

If you like what I'm doing…

 … consider buying me a coffee or joining my Club.

Tagi