Computer stand wide version
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
The original design wasn't wide enough for my case, so added pillars to be able to extend the top bracket
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 68
- Wydruki
- 1
- Wyświetlenia
- 445
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- Creative Commons — Attribution — Noncommercial
Original model was done by kafka. I remixed that model, and this is a remix of the remix. I added a center column to give it more strength while still maintaining the style/theme of the stand. This remix uses the entire width of the MK3 bed due to my case being wider than normal. You can adjust the negative volume of the .3mf file to size it to your specific case (be sure to center it if you change the size) . You can't use an outer brim due to the size
Printing perameters
Quality: .20 mm
Infill: 20% Gyroid
Supports: No
Loops: No = Needed to be turned off so it would fit on the plate at this size
Vertical Shells: 4