Cupholder for Baby Stroller
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a cupholder designed to hold a 67,5mm diameter cup/mug on a baby stroller with a frame diameter of 22mm.
- Ocena
- 4 / 5
- Polubienia
- 28
- Pobrania
- 109
- Wydruki
- 1
- Wyświetlenia
- 911
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other House Equipment
- Licencja
- Creative Commons — Attribution — Noncommercial
Hey there! I love coffee while going for a walk with the little one, which is why I designed this cupholder for a baby stroller.
It's designed to fit an insulated Yeti mug of the size 295ml/10oz. The inner diameter of the cupholder is slightly conical and ends up at 67,5mm as the tightest spot.
The segment of the stroller frame intended for mounting has a diameter of 22mm. Depending on the support material residue on the mounting interface, the fit might be tighter.
As for the material choice, we need to consider the levered load the liquid is representing and especially if paper-based cups are used with a hot beverage the strain the temperature induces. I printed in ABS which works perfectly so far, for insulated mugs PETG might also do the job, however, I think PLA's HDT is too low and creep behavior is disadvantageous.
Additional components for assembly
- Two M4x10 screws - longer ones will also work but protrude
- Two M4 screw nuts (hexagonal)
I also recommend mounting the coffee cup/mug towards you, as in case of failure you are not introducing the baby to coffee.
Hope this helps some fellow coffee or tea enthusiasts out!