Ananas Pen Cup (Vase Mode) with Lids and Separators
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Decorative Ananas Pen Cup can be printed in Vase Mode with several Lid and Separator options
- Ocena
- 5 / 5
- Polubienia
- 64
- Pobrania
- 180
- Wydruki
- 8
- Wyświetlenia
- 1009
- Oceny
- 5
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Office
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Details
I wasn't completely satisfied with my previous design so I fine-tuned that idea. And while I was perfecting those little bumps I started thinking about a solution to make it more rigid. The result is a lid that seamlessly fits into the pattern. I also added alternate versions with different cutouts (1, 2, 3 or 4 holes) and an organizer solution that can be printed without supports.
Dimensions (h x w x d): 102.7mm x 101.8mm x 101.8mm (basically 10.5cm x 10.5cm x 10.5cm)
Models
- cup: the base of the design, can be used alone
- top 1: this is the most simple lid, the only purpose is to make the cup more rigid
- top 2: simple lid with 2 holes on the top
- top 2 full: 2 holes on the top and 1 separator
- top 3: simple lid with 3 holes on the top
- top 3 full: 3 holes on the top and 2 separators (1 full- and 1 half-width)
- top 4: simple lid with 4 holes on the top
- top 4 full: 4 holes on the top and 2 separators (1 inner and 1 outer, check Assembly below)
Instructions for printing
I attached the .gcode file of all models for MK4 but in case you have a different printer all you have to do in PrusaSlicer (i use v2.6.0) is checking Spiral Vase on the Print Settings tab for the cup and it will add the necessary changes (like bottom layer, perimeter, etc).
The lids and separators can be printed with default settings, I didn't need to make any changes. All parts can be printed without support, just lay them flat next to each other!
You can print all parts with the same color or you can use different shades or even go crazy and use high contrast between the cup an inner parts.
Instructions for assembling
- lid/top: just push the lid into the vase (not too hard) and align to the top, it will stay there
- separator: slide the connectors into the cutout from the side and watch out for the order of the top 4 separators, there is an inner and an outer one
Test
Tested on an MK4 (v4.7.2) with some matte rainbow PLA filament from Sunlu what was surprisingly good.