Enclosure filament PTFE feed
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Roof cover for insertion of PTFE tube from top and QSM-M5 (with another PTFE) from bottom to allow easy filament change
- Ocena
- 0 / 5
- Polubienia
- 8
- Pobrania
- 62
- Wydruki
- 1
- Wyświetlenia
- 586
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution — Share Alike
With Prusa shifting MMU3 for MK4 by another three months, I wanted to set up easy filament change without a need to pull/push it within the enclosure.
This setup needs another QSM-M5 to be screwed into the cover, for the other end of the PTFE tube provided with the enclosure. This is not disconnected during filament change.
The other end is big just enough to comfortably slide in any of your other PTFE tubes from RepBox or other similar storage, but still can be easily pulled out.
Changing the filament with this means only drawing it (or using some rewinder) from the enclosure after unloading and sliding a new one in the hole.