Clockwork Pi uConsole external antenna mount.
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Portable Devices
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Have to pull the antenna out of its case, then you get to see how much wasted space comes in rubber duck antennas. I broke the bottom screw housing on mine, but it doesn't affect the antenna, and makes it a bit narrower.
You'll need a rp-sma to u.fl bulkhead pigtail, and a 5dbi rp-sma antenna. I used some vhb tape to attach to the uConsole's case.
I used ASA, but PET-G should also work, PLA is a maybe, as long as you're not going to leave it in your car. Also, prolly shouldn't use cf filled, not sure if that'll degrade the signal or not. Print with the largest side flat on the bed, so no supports are needed. Cover gets glued to the bottom.