Ikea Mojna UK Pendant Adapter
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Allows you to hang an Ikea Mojna lamp shade from a standard UK pendant without going back to buy the adapter.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 33
- Wydruki
- 1
- Wyświetlenia
- 183
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Home Decor
- Licencja
- Creative Commons — Attribution
Allows you to hang an Ikea Mojna lamp shade from a standard UK pendant without going back to buy the adapter you didn't realise you needed :D
Don't doubt this would work fine with PLA, I just had PETG loaded. I'm using it with an UK Bayonet (B22) LED bulb so the heat isn't an issue. This may be a problem if you're using an incandescent/filament bulb.
The long version is threaded and completely replaces the threaded part of a standard pendant. Since a B22 bulb is quite long, it also brings the shade further down so that it is more centred
The short version is not threaded and was intended to sit behind the normal threaded cap. I didn't use this in the end but have included it in case it's helpful for anyone. If you are thinking of using it, at 8mm thick, you may to check that the screwed part of the pendant will still screw on with this in place.
Print Settings
Printer Brand:
Creality
Printer:
Ender 5
Rafts:
No
Supports:
No
Resolution:
200
Infill:
20
Filament: eSun PETG White preferably
Category: Decor