Landroid wheels inspired by BMW
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
After about 4 years in my rough garden, it was time to replace my previous wheels (thing:3750909). This time I did not…
- Ocena
- 0 / 5
- Polubienia
- 9
- Pobrania
- 113
- Wydruki
- 0
- Wyświetlenia
- 842
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
After about 4 years in my rough garden, it was time to replace my previous wheels (thing:3750909). This time I did not care about material saving, print time or anything like that, I just wanted to make some nice looking wheels!
From my previous design, I extracted the studs and then made a new design based on the wheels on my BMW. When it was done, I also made a cap to cover the nut holding the wheel.
I haven't tested this design, but its made in the same way as thing:6207369 I published today, so it should fit well!
The cap snaps in place, but has a tight fit and brittle tabs so take it easy when mounting them. I added some slots to fit a screw driver when they need to come off.
Print Settings
Printer Brand:
Prusa
Printer:
I3 MK3S
Rafts:
No
Supports:
Yes
Resolution:
0,15 mm
Infill:
20%
Filament: Prusament PLA Galaxy black
Notes:
Should only need support for the hexagonal part. The rest of the wheel should print just fine without support.
Category: Robotics