Housing for Pi Zero with MakerSpot stackable USB-hub
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a housing to protect your precious Pi Zero paired with MakerSpots stackable USB-hub. I have tested it and…
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 34
- Wydruki
- 0
- Wyświetlenia
- 238
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a housing to protect your precious Pi Zero paired with MakerSpots stackable USB-hub.
I have tested it and customized it for Raspberry Pi Zero V1.2 and MakerSpots gen-2 stackable USB-hub.
The housing consists of two parts, the bottom part wich holds the hub and the top-part wich holds the Pi.
The bottom is tight but the hub fits, and is secured by 4 pcs M2.5 screws with a maximum lenght of 6mm.
The top-part is also secured with 4 pcs M2.5 screws with a maximum lenght of 6mm and has one hole for the GPIO header and one for a 12mm x 12mm heatsink.
Both pieces are then fit together and secured by 4 pcs M3 screws (i used 12mm long ones).
The plastic spacers, screws and nuts delivered from MakerSpot is not needed with this.
EDIT: 2017-10-15, Added a new TOP-part without holes for heat sink and GPIO header (requested by maferreira).
Category: Computer