Boruit Model:V10 pocket cover
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Cover for the Boruit Model: v10 to cover the buttons in a pocket.
- Ocena
- 5 / 5
- Polubienia
- 7
- Pobrania
- 53
- Wydruki
- 1
- Wyświetlenia
- 416
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Gadgets
- Licencja
- Creative Commons — Attribution — Share Alike
I got Boruit v10 flashlight awhile ago and the “Side” button when held down sounds an emergency alarm that was annoying in my pocket. So I made this cover that slides over it to keep the buttons covered in my pocket so its not an issue. It can also be put on the other way so you don't lose it when using the flashlight.
it uses 10mm by 1.5mm magnets I had to keep it on the flashlight in either direction. If you have other magnets I have included the freecad file. Sketch named Magnets defines the diameter for the circles, MagnetDepth is the actual pocket for them. I oversized them a bit with some trial and error but editing and reexporting “should” work. If you want me to make other versions for different magnet sizes please comment.
Note my charge port cover got lost so I don't know if that has any issues. If it does please comment and I will try to make a slot for it. Note with the actual charge cover the hole through the back probably won't work to charge very well so I might remove it.