1 / 3
Zigbee 4 Button Light Switch Mount
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
HIMOJO wireless scene switch mount for two gang light switch
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 22
- Wydruki
- 0
- Wyświetlenia
- 444
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial
This is a non-destructive holder for the HIMOJO Wireless Scene Switch that uses your light switch plate's screws as a mount.
You may notice a few identical Zigbee-compliant products from different brands. This is because they use Tuya designs. This holder can potentially fit other identical-looking 4 button switches. Check the dimensions below to make sure.
Switch dimensions:
- Width: 86mm
- Deep: ~13.2mm
Assumptions:
- Screw Hole Distance(center to center): 31.5mm
- Light Switch Plate Depth: ~6.7mm
Print:
- Material: PLA tested
Supports: Yes - Bed Adhesion: Skirt used. Use brim if you have bed adhesion issues.
- Orientation: Facing up
- Enable ironing
Install:
- Remove both screws from the top of the switch plate.
- Insert the 4 button scene switch into the rear of the mount, top first. The small lip at the top-rear should hold the 4 button switch in place when installing and using. It's normal for the print to flex a little when pressing the switch into it.
- Line up the holes on the print to the light switch plate.
- Hold the mount in place and screw the screws back into the holes. Do not over tighten.