Old Quaker oats jar lid
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Lid developed for the old Quaker oats jar, substitute for the original lid that began to deteriorate over time.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 29
- Wydruki
- 0
- Wyświetlenia
- 192
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Kitchen
- Licencja
- Creative Commons — Attribution — Noncommercial
Lid developed for the old Quaker oats jar, the original lid began to deteriorate over time, becoming extremely brittle and reaching the point where it broke and could no longer be used.
This lid should fit the square Quaker oats jar.
Four versions of this lid are available, with or without logo and with or without side texture.
- Print settings:
Recommended to print face up:
(Don't use "support interface")
Build plate adhesion type: Brim (recommended)
15% support density
Support overhang angle by 70°, (Threads do not need to be supported.)
Support type: zigzag (Easier to remove)
Obs:
After printing, it is recommended to use a Styrofoam disc inside the lid for better sealing.
A tolerance was considered for the inclusion of this Styrofoam disc, however the lid works normally even if the Styrofoam disc is not used.