Tube holder with PC4-1/8NPT Pneumatic fitting
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Added a pneumatic fitting and pivot to the classic tube holder for the Universal Automatic Rewind Spool Holder
- Ocena
- 5 / 5
- Polubienia
- 3
- Pobrania
- 50
- Wydruki
- 1
- Wyświetlenia
- 430
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Share Alike
While trouble shooting filament resistance issues setting up the MMU2S I found that the clamps for the ends of the PTFE tubes on my universal auto-rewind spool holders were creating a pinch point which increased resistance in the tube. To eliminate this problem I modified the classic tube holder from the spool holder model to accommodate a PC4 pneumatic fitting to hold the end of the tube. I also added a pivot to the arm so the filament always takes the most direct path into the tube.
Fully print-in-place, no supports needed. The pivot hinge should not take much force to release, just make sure your printer does not over-extrude for the proper clearance to be met.