Gridfinity Imperial Drill Bit Holder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Imperial drill bit holder (1/2" - 1/16") using the gridfinity standard base with additional bit storage tray.
- Ocena
- 0 / 5
- Polubienia
- 23
- Pobrania
- 114
- Wydruki
- 1
- Wyświetlenia
- 1266
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This imperial drill bit holder (1/2" - 1/16") uses the gridfinity standard base and houses all of my spare bits that I don't often use. I was constrained to a 4x3 footprint by the space I wanted to put this organizer, hence the tight arrangement. This left me with extra space that I turned into an extra bit storage tray. I printed this at a 0.3mm layer height with three outer walls at a 15% infill.
I recommend increasing the depth of the bits and the height of the side walls if you want this to stack. The largest three bits keep me from putting anything else gridfinity on it. Enjoy.