Flash Forge Adventurer 4 Hot Plate Connector Cover
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Hot Plate Connector Cover for the Flash Forge Adventurer 4
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 17
- Wydruki
- 0
- Wyświetlenia
- 281
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
The hot plate connector cover on my Adventurer 4 got deformed from the heat and no longer worked right. The cover's clip also broke because it was melted into place.
The original part was made from ABS. I recommend printing it in ASA since that holds it shape better at 100c.
This was reverse engineered from the original part that was deformed, but it will fit perfectly into place. Modeled in SolidWorks.
I left off the ribs on the top of the cover so that it could lie flat on the printer surface without supports. I used supports for my test print so the clip would not fail, other orientations did not fair much better. I found flat on the printer works best.
I did extend the clip part a bit more to grab the edge better.
The crease in the cable should be under the cover. It is left out in my picture to make taking the picture easier.