EGO Battery Mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a remix of a remix. Added a 2 degree bevel to make it easier to slide on the battery. Added 4 holes for 1/4…
- Ocena
- 5 / 5
- Polubienia
- 30
- Pobrania
- 145
- Wydruki
- 1
- Wyświetlenia
- 1545
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Vehicles
- Licencja
- Creative Commons — Attribution
This is a remix of a remix. Added a 2 degree bevel to make it easier to slide on the battery. Added 4 holes for 1/4 nuts. Also more holes for #6 tap screws. Made a 45 degree bevel for the round wire crimps. Took away some areas to save on plastic. I'm using PETG. I printed it laying flat with supports. Printing it tall was a failure for me. Too much support usage.
This is working great for my ebike.
Edit: After many months of use I would suggest you make the male connectors a bit taller than what is shown in my photos. It will make the connection that much better. Also I recommend using copper and silicone grease for a better connection.
Category: Vehicles