ADXL345 Y-axis mount for Elegoo Neptune 3 Max
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
An easy mount for an ADXL345 board for use when calibrating input shaping along the Y-axis of an Elegoo Neptune 3 Max.
- Ocena
- 5 / 5
- Polubienia
- 15
- Pobrania
- 168
- Wydruki
- 1
- Wyświetlenia
- 1425
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Share Alike
This model offers a convenient mount point for resonance-testing the Y-axis on the massive Neptune 3 Max. It uses the punched holes already present on the textured PEI sheet that comes standard with the Max.
It may work for other printers, too, but the holes are specifically aligned to the Max's bed sheet (A STEP file is provided for those who want to modify it for your own printer).
In addition to the model, you'll need the following screws, along with the ADXL345 itself and an MCU (I use a Raspberry Pi 3B) running Klipper or other input-shaping firmware.
- 2 M3x8 (or M3x12) screws w/ nuts to mount platform on bed
- 2 M3x12 screws w/ nuts to mount ADXL board to this platform.
Enjoy your printer!
Note: You should only keep this attached to the bed while you're performing resonance calibration, as the printhead may otherwise hit the ADXL or cable during bed-leveling or printing (although I suppose you could mount the chip under the PEI sheet if you wanted to make it permanent for some reason).