Connectable Hockey Puck Display Stand with rear visiblity
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I was attempting to have a set of pucks in a pyramid but if the desk or shelf was bumped the whole thing would just fall
- Ocena
- 5 / 5
- Polubienia
- 23
- Pobrania
- 116
- Wydruki
- 1
- Wyświetlenia
- 637
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Winter Sports
- Licencja
- Creative Commons — Attribution — Noncommercial
When trying to stack in a pyramid, the desk would get bumped and I'd have all the puck fall.
These are prototype remixes as it's the first one I've tried.
First attempt in Tinkercad. Still new to this so accuracy and tolerances likely off a bit.
Remixed the stand to use less material and an open back.
Added a peg to add some horizontal stability.
Created a Wedge to further add stability.
I printed at .28, and in the gray realized I printed in the wrong orientation, layers looks to be stepping but once puck on there it was ok.
Will need to print more of each to have the full pyramid of pucks.