Ratcheting paper towel holder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Ratchet allows 1 piece of paper towel to be taken at a time.
- Ocena
- 0 / 5
- Polubienia
- 31
- Pobrania
- 121
- Wydruki
- 0
- Wyświetlenia
- 1311
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Kitchen
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
THIS DOES NOT FUNCTION THAT GREAT. PRINT ONLY IF YOU WANT TO SEE HOW IT WORKS. There is too much friction and needs a redesign with bearings or something similar.
Printed in PLA with 6 walls and 35-50% gyroid infill.
Ratchet allows 1 piece of paper towel to be taken at a time.
Springs allow holder to fit multiple sizes of paper towel roll.
Force of ratchet can be adjusted by cutting down the number of ratchet springs. The print starts with 6, I only use 1.
The whole assembly takes 400-600g of filament depending on settings.
Assembly
- Press heat 3mm heat insets into “PT-Holder-RatchetCover”.
- Use m3 bolts to bolt together the ratcheting section to the “PT-Holder-HangerSide”
- Attach “PT-Holder-HangerSide” and “PT-Holder-HangerTop” and use the plugs to make the connection secure.
- Wrap rubber or something grippy around the springs.
Current Problems:.
When the paper towel roll is mostly used it gets a lot harder to spin.