Craftsman Combo Ignition Wrench
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Holder for "newer" Craftsman Combination Ignition Wrenches with recesses for 12mm magnets
- Ocena
- 0 / 5
- Polubienia
- 9
- Pobrania
- 46
- Wydruki
- 0
- Wyświetlenia
- 294
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution
Holder for the set of 10 Craftsman Combination Ignition Wrenches 42319 which are relatively thin. Remixed the original since my wrenches were thinner than those in the original file.
Recesses for 12mm x 2mm magnets in the bottom. I used 2 magnets in each hole for better holding power. The magnets keep them from sliding around as much, but won't keep them from falling out if turned over.
I printed with 0.4 nozzle, 0.2 layers, 15% Gyroid Infill, Organic Supports “everywhere” on my Sovol SV06+.
I added the text in PrusaSlicer before printing.