NEO Spacer for MaxDrive
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A 7mm spacer to allow your RevRobotics NEO to properly fit in your MaxDrive frames
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 25
- Wydruki
- 0
- Wyświetlenia
- 137
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution — Share Alike
If you are building a full-size R2-D2 astrodroid from wood or plastic, one of the better options for motors are the MaxDrives. These drives can use either old-school brushed CIM motors, or much more modern NEO brushless motors. But the output shaft on the NEO is about a quarter-inch too long, so it needs a spacer.
If you don't know what I'm talking about, you probably don't want this.
This is a very simple thing to work up, but having done it myself I figured I'd save other folks the bother and upload it here.
If you are interested in building your own R2-D2 or other astrodroid, go join Astromech.net! Be prepared to do a lot of reading, though. It's a complex project that usually takes folks a few years to finish.