Bambu Lab Y-Splitter with PC4-M10 pneumatic connectors and 10 x 2.65mm magnets
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
See Remix notes
- Ocena
- 0 / 5
- Polubienia
- 8
- Pobrania
- 100
- Wydruki
- 0
- Wyświetlenia
- 770
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Bambu Lab Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Remixed For two 10mm x 2.65mm round magnets.
Center fillet was not working in Rhino, so I just lofted a surface.
I printed this in PLA with the suggested settings. I had to clean out the X1 side a bit. I'm not sure if it was filament from the support interface, or unsupported housing filament that was a little stringy. I also had to switch from auto to manual supports to eliminate some unneeded interface filament showing up unattached to anything after slicing.
Layer height: 0.08mm
Walls: 4
Infill: 25%
Infill pattern: Grid
Enable Support: YES
Support Type: Tree (manual)
Support Top Z distance: 0.45mm
Support/object XY distance: 0.5mm
After about 2.5 years these seem to wear out if you use carbon fiber filled filaments periodically. You can reprint, or buy a splitter online.