Seville Classics Stool Chair Replacement Discs
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
These discs, when printed in TPU, replace the silicon parts of the Seville Classics stool.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 13
- Wydruki
- 0
- Wyświetlenia
- 124
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Mechanical Parts
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I got a Seville Classics Modern Ergonomic Pneumatic Height Adjustable 360-Degree Swivel Stool Chair (https://www.amazon.com/gp/product/B07QZ4TVZP/) years ago. This stool had 2 silicone-based dampeners/rings that allowed the stool to be used on an angle. They worked well for a while and then just crumbled….leaving the stool unusable.
So I modeled these rings to fully replace the 17mm ring on the bottom of the stool post and the 18.5mm ring on the upper part of the post.
I printed this with the only TPU I have, NinjaTek Ninjaflex TPU, with 0.6 nozzle, 90% infill (needs to be dense), and 0.30mm layer height.
To install:
- Remove the 4 black, hex head screws in the bottom of the stool with an Allen wrench
- Unscrew the 3 silver, Phillips head screws.
- Clean out all of the silicone inn the base and on the stool.
- Place the 17mm high ring on the bottom of the stool.
- You will need to cut the 18.5mm ring to fit it on the stool shaft. I could have put a gap in the model to make it easier but it was easy to just cut. Cut it and the place it above the metal ring on the shaft of the stool.
- Put the silver screws back
- Put the hex head screws back
- You now have a working stool!