Gear and Arm for Ecovacs Deebot OZMO T8+
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This gear + arm replaces the piece that the front spinning brushes snap onto within the left and right motors.
- Ocena
- 5 / 5
- Polubienia
- 24
- Pobrania
- 232
- Wydruki
- 1
- Wyświetlenia
- 2004
- Oceny
- 3
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other House Equipment
- Licencja
- Creative Commons — Attribution — Noncommercial
While I was trying to pull off the brushes on my Ecovacs Deebot OZMO T8+ I accidentally broke the green gear+arm that the brushes snap onto. I was bummed out until I remembered I could design and print a replacement part to fix it!
I took apart the vacuum to locate the missing piece, took measurements, and modeled it in Fusion360. It took a while and a decent amount of tweaking to get the gear to fit perfectly. Made some slight adjustments to strengthen the gear+arm, including not modeling holes and adding a larger brace between the claw portion.
While I made this for the OZMO T8+, it would definitely fit a lot of other Ecovacs vacuums with little to no modifications. I have another Ecovacs vacuum (different model) that would fit it.
Printed at 100% infill on PETG. Used supports, but no towers. Didn't need a brim or anything.