Dacia Duster 2018 parcel shelf/trunk cover cord washers
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Wstępna wycena dla PETG
0,05 € – 0,06 € netto (bez VAT)
Dla pliku: Bricka_0.6n_0.3mm_PETG_MK3S_3m.gcode
To wstępna wycena jednego pliku. Dokładną cenę poznasz przed zamówieniem.
Plik i założenia wyceny
Plik użyty do wyceny
Średnia wycena orientacyjna: 0,05 € netto (środek widełek).
- Masa podana przez autora
- 1 g
- Czas druku podany przez autora
- 2,4 min
- Materiał u źródła
- PET
- Materiał wyceny
- PETG
- Drukarka wyceny
- Bambu Lab P1S - 0.4 nozzle
- Proces wyceny
- 0.20mm Standard
Orientacyjna wycena wyłącznie wybranego pliku, oparta na masie i czasie druku podanych przez autora. Warianty plików nie są sumowane. Ostateczna cena zostanie obliczona po analizie pliku.
Zapisane na tym urządzeniu.
Replacement washer for the cords for the parcel shelf/trunk cover of a Dacia Duster 2018+
- Ocena
- 0 / 5
- Polubienia
- 9
- Pobrania
- 91
- Wydruki
- 0
- Wyświetlenia
- 1516
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Automotive
- Licencja
- Creative Commons — Attribution — Share Alike
Replacement washer for the cords for the parcel shelf/trunk cover of a Dacia Duster 2018+.
The factory rubber bar thing is not very well made and easily falls out, it is basically a rubber cross bar that you slide over a knot in the end of the cord. Replicating this was not a good idea. Instead this is a replacement hard washer. This is the design that Dacia should have used.
This washer is sized so that the cord should fit through, but with a knot it should not slip through. The hole is slightly oval as the cord is also oval.
Printing instructions
Print in PETG or another high temperature material (PLA is not suitable for cars, gets too hot in the summer and it will deform).
I printed this with 0.6 mm nozzle using PrusaSlicer and the Arachne perimeter generator. Some tweaking may be needed if using 0.4 mm nozzle.
Installation
- Pull cord through the hole in the shelf and the washer.
- Tie a large knot so that it doesn't slip through the hole.
- Throw the factory part in recycling/trash (make sure to follow local regulations).
The part was modelled in OnShape, here is the source document: https://cad.onshape.com/documents/1863c5c40397875b55aa8a47/w/a2ea53f522b2e4c259b38609/e/9f0ae24c2be6a75b2197a9a4?renderMode=0&uiState=6508b69fd4875e3092e31f2e