1 / 7
Hydraulic Disc Brake Alignment Tools
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Toolset to easily center your hydraulic disc brakes on your bike.
- Ocena
- 5 / 5
- Polubienia
- 156
- Pobrania
- 1059
- Wydruki
- 6
- Wyświetlenia
- 4579
- Oceny
- 7
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor Sports
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
SzczegółyPliki (15)Wydruki i komentarze (Wydruki: 6) (Komentarze: 7)Remiksy (0)Kolekcje (260)Powiązane
Print instructions:
- I printed all the tools in PLA and they're holding up perfectly fine.
- The ideal thickness of the caliper alignment tool is 0.35mm. So set your first layer to 0.2mm and print with a layer height of 0.15mm. I printed everything else with a layer height of 0.2mm.
- To make sure the rotor truing tool is strong enough I suggest using 4 perimeters and to print it in the provided orientation.
- I inserted one 5x1mm magnet into each of the caliper alignment tools. This makes it easier to use them, but they also work fine without.
How to use:
- Remove the wheel.
- Loosen the break caliper screws.
- Use the wedge to push back the brake pad pistons.
- Re-insert the wheel and place both caliper alignment tools on the break disk. Then rotate them into the break pads.
- Engage the breaks and tighten the brake caliper screws.
- You're done! If necessary, use the rotor truing tool to fix bends in the rotor.
(I prefer version A but version B is the more traditional design.)
Do not engage the breaks while the wheel is removed! It can push out the pistons and it will get messy!