Improved replacement drip tray for the GRP1060B 4 Serving Foreman grill
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Improved design for the 4 serving Foeman Grill with fillet corners for improved strength.
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 53
- Wydruki
- 0
- Wyświetlenia
- 395
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Kitchen
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I somehow how misplaced the drip/grease tray from my 4 serving Foreman grill. Without the drip tray, the Grill is unusable. By design, when frying hamburger or other meat on the grill, hot grease flows safely off the bottom edge of the grilling surface, and into the drip tray, rather than your countertop.
This should be printed from PETG (or better) without a brim or supports. The tray is 11" wide, and barely fits on the i3 build plates if oriented at an angle from corner to corner. If you add a brim, it will no longer fit.
Though PETG doesn't tend to warp as much as PLA, with a piece this size, ensure your build plate is clean to help ensure good adhesion, be sure to use a heated bed, limit exposure to drafts and external cooling as much as possible to limit warping. I did not have warping using a satin build sheet on a i3 MK3S that was not enclosed. I used black PETG from Overture.
See the screen shots here for a picture of an OEM drip tray, and the design offered here.