Simple Single-Channel Relay box
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a simple enclosure for a relay box to be controlled by Raspberry Pi or Arduiono. Use at your own risk.
- Ocena
- 4 / 5
- Polubienia
- 13
- Pobrania
- 125
- Wydruki
- 0
- Wyświetlenia
- 625
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a simple enclosure for a relay box to be controlled by Raspberry Pi or Arduiono. Use at your own risk specifically when dealing with AC workloads.
The design was built in order to be simply printable with FTM printers and featuring sufficient tolerances for most printers (I hope). It should be very easy to print.
In case your relay module does not fit exactly you might cut off the mounting pins and clips to make it a loose fit.
The design featuring 2 channels (one on top and one at the bottom) to fit zip ties in order to fix the cables to the base. You can either close down the box by using a single screw or simply use the zip-tie channels on the top and bottom for tool free assembly. So you might entirely use this design without any tools or screws. Just a bunch of zip ties (5 in total).
Of course you can also glue the enclosure.
You might use simple Relay modules like this one.
Inspired by Relay Control Box
Print Settings
Printer Brand:
Anycubic
Printer:
Vyper
Rafts:
Doesn't Matter
Supports:
Doesn't Matter
Resolution:
0.2
Infill:
20% Gyroid
Filament: Any PLA Any
Notes:
No special settings required. Tolerances should be sufficient for most printers.
Category: Electronics