ESP8266 Enclosure
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Remix of a NodeMCU case to fit a HiLetGo board.
- Ocena
- 0 / 5
- Polubienia
- 21
- Pobrania
- 229
- Wydruki
- 0
- Wyświetlenia
- 1840
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution
I printed the enclosure by jperson(on thingiverse) thinking it would fit my ESP8266/NodeMCU board but it was apparently designed for a different, larger dev board. The holes for the pins fit perfectly though and I liked the form factor a lot, so I adjusted it to fit my board, which just required moving the sides in a little bit.
The board I used is by HiLetGo and measures ~25x48mm.
Print Settings
Printer Brand:
SeeMeCNC
Printer:
Rostock MAX v3
Rafts:
No
Supports:
No
Resolution:
200
Infill:
20
Filament: Overture PLA
Notes:
The bridges in this are short enough that there shouldnt be any need for supports.
Category: Electronics