Pi Cam V3 Simple Case and Holder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A very simple Case for a Raspberry Pi Cam V3 with holder.
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 66
- Wydruki
- 0
- Wyświetlenia
- 287
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Share Alike
A very simple Case for a Raspberry Pi Cam V3 with holder. I needed a holder with a screwhole that can pivot.
Very easy to print. No supports needed. Just make sure to rotate the Holder-Part by 90 degrees in your slicer and lay it on its back.
Use an M4x20 screw and nut to hold the back to the holder.
If your printer makes no perfect holes, just drill them out using a 4.0mm drill bit.
Two holders are included - a longer and a shorter version.
Remark: This is my first design that I did mostly to learn CAD - if you have any comments please feel free to share them.