Comet pump (Tauchpumpe) to Gardena Adapter
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This adapter connects - Gardena hose connector - hose with an inner diameter of about ø10-11,5mm (Comet pump)
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 34
- Wydruki
- 0
- Wyświetlenia
- 459
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Automotive
- Licencja
- Creative Commons — Attribution — Share Alike
This adapter connects
- Gardena hose connector
- Hose with an inner diameter of ø10-11,5mm (in my case hose of Comet submersible pump (Tauchpumpe).
Remix
This adapter is essentially based on the data of the "Air to Gardena Fitting Adapter" from adynis.
Purpose
I have for our VW T4 bus a water tank incl. Comet submersible pump installed in the cabinet. The submersible pump is to operate an outdoor shower. So that the shower does not always have to be mounted, I have installed this adapter.
Mounting
The hose of the Comet submersible pump is mounted in the cabinet. The cabinet has a wall thickness of 19mm. After that follows the Gardena adapter. This adapter is mounted on the outside of the cabinet using two countersink screws (there are certainly better suited screws, however, I only had these).
In addition, I have developed a plug to stop water running down. This is kept simple, but serves its purpose.
Printing
I printed this adapter with the Gardena adapter up (support on built plate only). PLA was sufficient for me.
Additionally you will need
- Gardena rubber seal
- 2x M4 countersink screws