Piantor Keyboard Case
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
case for piantor that has a mount for a super clamp type attachment.
- Ocena
- 0 / 5
- Polubienia
- 17
- Pobrania
- 84
- Wydruki
- 1
- Wyświetlenia
- 1726
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- Creative Commons — Attribution — Noncommercial
use a ¼ 20 hex nut. insert from bottom with a clamp. I used a coin while pressing the nut in, to create a flat surface for the clamp. The switch plate I used is from the Piantor Github repo. That is held in place by 6 m2 screws on each side.
Mirror the model in your slicer to make one for each hand. I used a modifier in my slicer to add additional infill density to the area around the hex nut. I intended to use brass inserts to attach the m2 screws, but I made the standoffs too narrow to do this. I used long enough screws to reach past the standoffs and thread into the smaller diameter holes directly under them
Added tents that screw in with a 1/4 20 bolt if you want to use them in place of the super clamps. I also used longer M2 screws (the 2 closest to the pico), probably not needed.