Canon RF to EF mount Tilt Shift adapter

This is a fully printed canon RF body to EF lens Tilt adapter. It allows you to create the “tilt shift” effect with any EF lens. It will also work with any EF body to other lens adapters, I've personally used Nikon F mount, Olympus OM mount, and M42 mount lenses, but any mount with an EF adapter will work well

Note that certain EF lenses wont be able to focus if they use focus by wire as there is no electrical connection. You will also have to use this technique to change aperture.

The adapter is a bit difficult to print, supports will be required. Print 2 of the lock parts and print the tilt part sideways so the tilt motion is smother. Must be printed in black. Works fine at 0.2 layer height. It is decently strong but don't go waving your camera about with a heavy lens on it, keep one hand on the lens. 

It has around 7 degrees of tilt each way and 180 degrees rotation giving full coverage. It tilts around the center of the sensor so focus stays the same in the middle of the picture. 

Have Fun!

UPDATED 2024/07/12
Slightly updated tolerances, might require a bit less post processing to make fit.
Added a simpler and stronger lens locking mechanism, requires an M3x8mm thumbscrew and a 4x4 M3 heated insert. There is a step file with a flat face at the correct location as well, so if you want to use a different size insert or bolt you can use that.